code 6

We may earn a small commission from affiliate links and paid advertisements. Terms

boosted_ek

Junior Member
So i got my swap finished b20 into an ek (p06 chipped with a p75 map). I have a code 6 (coolant temp sensor) Now I swapped sensors with my old one off my d16 (it fit fine) But I still have code 6. I have the rad full of coolant (haven't let it run 2 cycles yet to finished the flush) but I know for a fact that the new sensor I put it was operating normally. Could it be that I'm not done my coolant flush? (which I doubt) or do I need a b-series CTS?

Any suggestions?
 
Back
Top