1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Code 9 after obd0 to obd1 swap

Discussion in 'Civic and CRX - EF' started by drsessum, Apr 24, 2010.

  1. drsessum

    drsessum New Member

    Likes Received:
    Jul 1, 2009
    I know that this thread is old, but I haven't found any solutions in the postings. I have an 89 CRX with a B16a and I converted it to OBD1 using a Zerg harness and a TD44u dizzy. The dizzy is new (Bortek). I got it locally. The timing is correct. The engine runs just fine except the CEL is throwing a code 9 (cyp). I checked the wiring back to the obd0 side of the conversion harness and it is good. I have spliced a yel/grn wire to the fat white wire on the obd0 side of the dizzy.

    My question is: Are the wires supposed to match up by color when doing this conversion.? Also which of the 3 pickups inside the dizzy is the cyp...the one with a single spoke, the one with 4 spokes or the one with a lot of spokes?
Draft saved Draft deleted

Share This Page