1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

crank pulley ?

Discussion in 'Engine Building' started by Jay Bird, Jun 8, 2011.

  1. Jay Bird

    Jay Bird New Member

    Messages:
    21
    Likes Received:
    0
    Joined:
    Jun 3, 2011
    I am starting my first engine rebuild on my 86 CRX HF(EW1)

    After the rebuild is done, will I have to have the crankshaft pulley ballanced if I am putting the stock pulley back on or just when you change the pulley?
     
  2. Jeef

    Jeef NO MA'AM Moderator VIP

    Messages:
    7,150
    Likes Received:
    294
    Joined:
    Sep 29, 2002
    Location:
    CT
    I started a new thread with your post. That other thread was from 2003.
     
  3. wikedeye

    wikedeye Well-Known Member

    Messages:
    1,772
    Likes Received:
    57
    Joined:
    Dec 14, 2006
    Location:
    Savannah, Ga.
    If you are using the original pulley then I dont see any reason why you would have to get it balanced.
     
  4. K2e2vin

    K2e2vin Senior Member

    Messages:
    8,446
    Likes Received:
    92
    Joined:
    Jan 2, 2003
    Location:
    Raleigh, NC
    :werd: Possibility of crank pulley being out of balance is very low.
     
  5. Jay Bird

    Jay Bird New Member

    Messages:
    21
    Likes Received:
    0
    Joined:
    Jun 3, 2011
    Thanks for the info
     
Verification:
Draft saved Draft deleted

Share This Page