1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Crx b18 swap not starting...

Discussion in 'Civic and CRX - EF' started by fuckv8, Aug 26, 2010.

  1. fuckv8

    fuckv8 New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Aug 26, 2010
    Hey everyone. So im swaping a b18a1 OBD1 in my 90 crx dx and i've just used my dx harness and followed directions for this website here, MPFI Swap. Its an MPFI swap so i just followed every single direction from that. Using a PR4 ECU. No check engine light is on, the motor is cranking, i am getting fuel, main relay is good, i am getting spark, just changed the cap, rotor, spark plugs and wires and still nothing.. checked all fuses. checked all grounds. batt started dying out so i re-charged it.. Theres a half tank of gas, theres plenty of oil. went over the wiring hella times, and everything is plugged in. Help please!!
     
  2. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    Check all the grounds again, make sure you used them ALL, and then check the timing.
     
Verification:
Draft saved Draft deleted

Share This Page