CTR Pistons in a B16

[THEUSED]

Do you have to machine stock rods in a B16 to clear Oversized CTR Pistons the ones that are overbored .25

 

[MikeBergy]

Originally posted by THEUSED@Aug 22 2004, 01:14 AM
Do you have to machine stock rods in a B16 to clear Oversized CTR Pistons the ones that are overbored .25

[post=380206]Quoted post[/post]​

You either have to machine the small end of the conrod, or machine the inside of the piston, because the small end of the conrod for a b16a is wider than than of a b16b. The fact that the piston is oversized .025?? I am assuming you made a typo, just means you will have to have your block bored .025 and then honed to fit the oversized pistons in there.