1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

d16

Discussion in 'Engine Building' started by bigharp_civic, Oct 15, 2006.

  1. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
    ok i just bought a y8 head for my z6 and i am going to put it on, does anyone know where to go to find out how to put it all in time i know where the timming marks are i just need to know where to put them and how to put the distribuitor in and have it timed
     
  2. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
    well thats what i mean i have seen things timed different do i line it up with the top of the head or do i line it up with the crank timing mark
     
  3. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
  4. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
    ok just put a y8 head on my z6 block and it runs ok at idle and at higher rpm but when u push the gas peddle it bogs down for about 3 secs like nothing is happening can anyone help me
     
  5. bigharp_civic

    bigharp_civic New Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Sep 18, 2006
    ok i just want to know what piston and rods can i put in a z6 block to raise compression is it the a2 or a6
     
Verification:
Draft saved Draft deleted

Share This Page