1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

d16y8 harness

Discussion in 'HYBRID -> EG-EK / DC' started by dustinp, Sep 9, 2009.

  1. dustinp

    dustinp New Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Dec 15, 2008
    Location:
    kentucky
    i hope someone here could give me a few pointers ive asked this question on other sites and they remained unanswerd..i am about to swap a obd1 b18b into my 98 civic ex..it was previously in my friends eg so i get everything i need axles ecu ect...i was curious which would be the easier route to take...buy the ecu jumper harness from boomslang and use my harness with the obd1 ecu or swaping out my current d16y8 wiring harness with the one he used for his car and not getting the jumper harness...if its easier to keep my harness which i hope it is, will all the sensors and plugs match up besides vtec and knock sensor of course...any info could be helpful thanks
     
  2. D16SiHatch

    D16SiHatch New Member

    Messages:
    1,297
    Likes Received:
    44
    Joined:
    Sep 7, 2007
    it's easier to keep your stock harness, and that's what you're supposed to do whenever doing an engine swap (only exception being k-series). get yourself an obd2-obd1 jumper, plug in the obd1 ecu, and you'll be good to go.
     
  3. dustinp

    dustinp New Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Dec 15, 2008
    Location:
    kentucky
    thanks will all the sensors and connectors hook up besides the vtec n knock
     
Verification:
Draft saved Draft deleted

Share This Page