d16z6 all motor/spray?

[HondaElite]

well ive aquired a z6 block from a junkyard..anyway i wanna go somewhat all motor nothing crazy...ive about P29 pistons and getting the z6 rods peened?i wanted to knoe what peening is?..and what head work would i need besides 3 angle valve job or P/P...the deck and head are stock...never milled or cut so im going with a oe h/g..and i have a little 10oz NOS bottle with a dry 50 shot...should i get a nitrous cam? or stage 3? and will it even handle the spray with 12.3:1 i believe it will be...or should i just stick with the n/a? lookin for alota info before i get into the project..thanks

 

[phunky.buddha]

P&P, aggressive cam, really good tuning... and yes, you can run nitrous on compression that high if you're tuned to compensate. Back off timing, have really good fuel etc. The cast pistons might give up after a while on cylinder pressures that high though.