1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

d16z6 throwin code 7

Discussion in 'HYBRID -> ED-EF / DA' started by sleepercivic69, Nov 9, 2006.

  1. sleepercivic69

    sleepercivic69 New Member

    Messages:
    52
    Likes Received:
    0
    Joined:
    Sep 7, 2006
    well finally got my car up and runnin but its throwin a code 7 which is the tps but the funny thing is the car runs fine. the tps voltage reads 4.5 which i know is not right but there doesnt seem to be anything wrong with it. should i just go ahead and switch the outer wires around and see what happens?
     
  2. AHHVTEC

    AHHVTEC Well-Known Member VIP

    Messages:
    13,122
    Likes Received:
    245
    Joined:
    Oct 13, 2006
    Location:
    Alabama
    well anytime you get a code something is not right wether it runs right or not
     
  3. nikozai

    nikozai New Member

    Messages:
    60
    Likes Received:
    0
    Joined:
    Oct 16, 2006
    flipping the outer wires for what purpose?
    Was your car a DX/STD... if so, then yes you must flip the outer wires.
    Other than that... see the TPS calibration info in the CRX workshop manual
    NorCal CRX Club (left hand side links)
     
Verification:
Draft saved Draft deleted

Share This Page