1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Dampner pully problem

Discussion in 'General Tech and Maintenance' started by rmacomaha, Mar 9, 2004.

  1. rmacomaha

    rmacomaha Junior Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Mar 9, 2004
    We are trying to change timing belt on 91 Accord single over head cam. We can't get the bottom nut/pully off to get the bottom shield off. We are holding the pully with large rubber strap wrench, so far have twisted cheap 1/2" 10" extension by using 3' cheater pipe and 2' breaker bar. I have also tried air impact to no avail. We are also turning counter clockwise. Any suggestions?
     
  2. cycloneb18c3

    cycloneb18c3 Senior Member

    Messages:
    1,056
    Likes Received:
    0
    Joined:
    Aug 10, 2003
    Location:
    New Jersey
    i think u mean the crank pulley... use an impact wrench(a good one).
     
Verification:
Draft saved Draft deleted

Share This Page