1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

distributor wiring for f23a1

Discussion in 'Prelude' started by hondajunkie92, Oct 21, 2009.

  1. hondajunkie92

    hondajunkie92 New Member

    Messages:
    5
    Likes Received:
    0
    Joined:
    Oct 14, 2009
    Location:
    texas
    i swaped my h23a1 out of my 92 prelude and out in a f23a1 how do i wire the distibutor?
     
  2. runningbull

    runningbull New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Nov 10, 2009
    Location:
    Tenn.
    I just done the same thing to my 92 Prelude....I ran a hot wire from the only hot wire from the ciol plug to the 94 accord ex distrib.Open the distrib. an follow the wire from the internal coil jump the wire across an she will fire up...And then you will have to replace the ECU with a 94 accord Vtec one... http://hondaswap.com/general-tech-articles/how-wire-vtec-40811/I hope this helps .:FFS TechNet : OBD1 ECU Pin out Schematics :. Let me know if this does it for you..Make sure you change ALL the sencores...I even used the Hmodel throddle body on the intake made a big deffrence...Oh yea make sure you swap A6 to A11 on your ECU.....
     
  3. eejjkk

    eejjkk New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Oct 13, 2010
    I am also about to do this same swap (spun crank bearing on my H23 and found an F23a1 for 200$). Anything I should know or any pointers before I get started? I'm going to get the motor this weekend and get started.

    Any help would be greatly appreciated. ^_^
     
Verification:
Draft saved Draft deleted

Share This Page