1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

does anyone know how to fix error code 8

Discussion in 'HYBRID -> EG-EK / DC' started by entone, May 5, 2005.

  1. entone

    entone Junior Member

    Messages:
    20
    Likes Received:
    0
    Joined:
    Mar 22, 2003
    does any know how to fix error code 8 (TDC senser), it comes on when im driving ,i turn the car off and turn it back on, and its gone, but it comes back after i drive again, i check all the plugs and everything seems fine. dose anyone know how to fix this. by the way its a eg with jdm b18c swap.
     
  2. 96CIVICLS

    96CIVICLS Senior Member

    Messages:
    202
    Likes Received:
    0
    Joined:
    Apr 7, 2005
    check the wires from the dizzy to the ecu to make sure there not bad and are working properly. the colors are white/blue and org/blue check that and let me know. on the ecu they should be c3 and c13 for ground. ground is the white/blue and power is the org/blu. check for voltage. if all is good you have a bad sensor and the whole dizzy should be changed. just chaging the sensor alones gonna cost you more then what you wanna fork out for somthing else in the dizzy to go bad and have to do the same thing over and over agian. let me know if this helps.


    ya boy steveo
     
Verification:
Draft saved Draft deleted

Share This Page