1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Driveshaft problems

Discussion in 'General Tech and Maintenance' started by Franknstein, Aug 3, 2004.

  1. Franknstein

    Franknstein Member

    Messages:
    43
    Likes Received:
    0
    Joined:
    Mar 16, 2004
    When I pulled my long-side driveshaft out the other day, I saw that the end of the inner spline shaft (which locates inside the diff) was completely graunched just before the circlip, the rest of the spline was fine. So I got a new one and tried to put it in, but it just didn't want to clip in! Pushed it in as best I could and took her for a spin, and sure as damn, it popped out. My question is do you think the locating section inside the diff is screwed or do you think the circlip on the inner cv housing spline is stuffed?
     
  2. asmallsol

    asmallsol Super Moderator

    Messages:
    8,074
    Likes Received:
    3
    Joined:
    Sep 28, 2002
    Location:
    Houghton/Livonia Michigan
    sometimes the little c-clip on the on the AXLE (not drive shafts) are pretty hard to get in. Try harder.
     
Verification:
Draft saved Draft deleted

Share This Page