ECU Pin Tool

We may earn a small commission from affiliate links and paid advertisements. Terms

Citizen_Insane

Citizen_Insane

Senior Member
Does anyone know the Honda part # for an ecu pin tool? I will be needing one when it comes time for the swap.
 
A teenie screwdriver will work. The harness end is made to open. After that, you merely depress a small tab on the pin itself. Or, a good firm yank might do the trick. I wouldn't spend $$$$ on a tool to use once unless I REALLY needed it.
 
It depends on what year you have. From what I have read, older cars (preOBD) harness did not have the swinging covers. Both time when I wired up the ECU, I just had a pin, soldered it up to the wire that I was running, found the right spot, then just stuck it in. The one that I made a mistake on (location) I just gave it a quick yank, and it came out. Just make sure that they go in all the way.
 
You must log in or register to reply here.
Back
Top