1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

engine/stand bolts WOES

Discussion in 'General Tech and Maintenance' started by mountaindewguy, Jan 31, 2006.

  1. mountaindewguy

    mountaindewguy Junior Member

    Messages:
    24
    Likes Received:
    0
    Joined:
    Jan 29, 2006
    ok, just bought an engine stand from AC DELCO, but i need to buy the actual 4 bolts that go into the engine seperately... does ANYONE know the size/specs of bolts i need? thanks!
    will be going on a LS block.
     
  2. driver1

    driver1 Senior Member

    Messages:
    1,979
    Likes Received:
    0
    Joined:
    Jan 15, 2003
    if you already have the engine that is going on the stand just take a copule of your bell houseing bolts and bring them to a hrdware store and get some the same diameter and thread pitch but just about 2 inches longer to go through the stand bolt holes
     
  3. VTECPOWER

    VTECPOWER Senior Member

    Messages:
    1,683
    Likes Received:
    0
    Joined:
    Oct 6, 2003
    Location:
    Winchester, VA
    :werd: Just make sure they are the same grade or stronger.
    Don't wanna drop an engine now do we?
     
  4. mountaindewguy

    mountaindewguy Junior Member

    Messages:
    24
    Likes Received:
    0
    Joined:
    Jan 29, 2006
    ..bell housing...? just got off work, please.. refresh my mind lol
     
  5. K2e2vin

    K2e2vin Senior Member

    Messages:
    8,446
    Likes Received:
    92
    Joined:
    Jan 2, 2003
    Location:
    Raleigh, NC
    the bolts that hold the transmission to the engine...
     
  6. mountaindewguy

    mountaindewguy Junior Member

    Messages:
    24
    Likes Received:
    0
    Joined:
    Jan 29, 2006
    k gotcha lol.

    i slept now haha.

    so basically get longer bolts to go through the 4 posts in the engine stand, and into the transmission mounting holes?
     
Verification:
Draft saved Draft deleted

Share This Page