Exhaust Piping Question........

[crex3]

OK........I have a CRX that oneday max will be pushing 170to200hp. What size piping and does any one know the piping bends/ dimensions (or place to order) so I can get custom piping that allows my ractive muffler to come out the drivers side of the back bumper. Thanks guys. Sorry if was vague any where in my question.

 

[NotUrAverage_Si]

did you try a local muffler shop?

 

[B18aCRX]

If you are going NA, you should stay around 2.25". If you are going FI, then larger is better.

Mandrel Bends > Crush Bends


Check Here for Tubing


Edit* My response was assuming that you can weld

 

[ExplicitSnow]

you want custom exhaust...go to this website, www.kteller.com

theyve got a 2.5" mandrel bent catback system for $215...all you need is it installed/welded together...it included hangers, flanges and all pipes

they also have 2.25" and 3" for the crx...piping diameter really depends on modifications you have...turbo, you want 3"...naturally aspirated, go w/ 2.5", it works really good on my crx...sounds awesome too

 

[Citizen_Insane]

Explicit what muffler are you running?

 

[ExplicitSnow]

2.5" inlet, 4"outlet, titanium

90 crx si w/ d16a1 dohc zc
cold air intake
8200 revlimit ecu
B&M short shifter
2.5" madrel bent piping--no cat--stock header for now
F/R upper strut bars
F/R lower tie bars
coilovers
stripped interior
carbon fiber seats <--delivery in 2wks