1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

F23A1 with H23A1 head

Discussion in 'Engine Building' started by MisterV, May 2, 2015.

  1. MisterV

    MisterV New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    May 2, 2015
    Recently acquired a F23A1 and I wish to do a DOHC swap using a H23A1 head. I will be boring out the block to better match the H23A1 head.

    My question is to raise CR, can I hang H23 pistons on the F23 rods ?
     
  2. MisterV

    MisterV New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    May 2, 2015
    All this will be going into an automatic to manual converted EJ8. Figure keeping the B manual would make the overall swap easier.
     
Verification:
Draft saved Draft deleted

Share This Page