I have for sale my beloved 1990 Honda Civic DX Hatchback.
Clean Title.
I am located in Baltimore, MD 8 Miles (10 Mins) from I-95.
No shipping is included.
Bring your trailer and a friend.
Pictures Are Clickable for Larger images.
Interior:
-Blue
-Very good Condition
-Driver's Side Seat has just recently acquired a tear in the "usual spot". SEE PIC.
-Other than that, interior is in perfect condition.
Exterior:
-White
-Very good Condition
-Hood has some rock chips, BUT you're putting a CF hood on anyway right? SEE PIC.
-Passenger side has 2 SMALL, I MEAN SMALL dings. You really have to know where to look to even find them.
-Drivers side has 1 SMALL, I MEAN SMALL ding. Very hard to see on a white car.
-Small rust spot on bottom of rear quarter. SEE PIC.
Engine/Drivetrain:
-B16 cable tranny, NO GRINDS. Excellent condition.
-Tranny comes with starter.
-Tranny has NEW throwout bearing 8,000 miles old.
-Will include Clutchmasters heavy duty pressure plate 8,000 miles old.
-Will include Clutchmasters 6-Puck Cerametallic Disk. (Needs to be replaced)
-90-93 Integra axles. About 15k miles on axles. They were bought brand new.
-Will include 90-93 integra intermediate shaft.
-Cold Air Intake. (Needs new filter).
-Custom adjustable shift linkage.
-HCP Engineering EF18-X Motor Mounts. Passenger mount has tear in Poly. SEE PIC.
-New Radiator 15k Miles ago.
-Radiator hoses for b series swap.
-Stock exhaust with Cat to pass inspection.
-Custom Header Back 2 1/4" Exhaust. No Cat. With ractive muffler w/DTM tip.
-Stock crossmember.
-Modified crossmember for use with turbo, big header.
-B&M Fuel Pressure Gauge
-90-93 Integra Rear Mount
Electronics:
-Car is converted to OBD1, with JK OBD0-OBD1 conversion harness.
-Hondata Stage 2 N/A with ROMEditor Software, Chipped p28, Chip Burner all setup to tune your own car!
-Car is setup for use with peak & hold injectors. I have a set of stock 240's 15k miles old.
-Aiwa Mp3/CD Player.
-Sony XPlode 5 1/4" Speakers in doors.
Suspension/Wheels:
-Front rotors are 15k Miles old.
-Comes rolling on CRX Si Rims.
-I have two brand new tires to go with the car as well.
-Ground Control Coilovers BRAND NEW. Not installed.
-KYB GR-2 shocks BRAND NEW. Not Installed.
What you will need:
-B-Series DOHC VTEC Longblock with flywheel. (B16aX, B17a1, B18cX, ls/vtec, crv/vtec)
OR
-non-VTEC B-Series Longblock, you'll have to run an OBD1 LS ECU. And you can sell the Hondata setup for about $500. (B18aX, B18bX, B20bX, B20zX)
-90-91 Integra Clutch Disk. Doesnt matter which.
And thats it! You're ready to roll the fuck out!
Asking Price is: $2300 OBO.
Do your homework and see that this is an excellent price.
"Money talks, bullshit walks."
The car will be considered "FOR SALE" unless a deposit is made to my paypal account.
NO EXCEPTIONS.
If you have further questions, PM me for my Cell #.
AIM: FORCEinductedED6
Thank you and have a nice day.
Clean Title.
I am located in Baltimore, MD 8 Miles (10 Mins) from I-95.
No shipping is included.
Bring your trailer and a friend.
Pictures Are Clickable for Larger images.
Interior:
-Blue
-Very good Condition
-Driver's Side Seat has just recently acquired a tear in the "usual spot". SEE PIC.
-Other than that, interior is in perfect condition.
Exterior:
-White
-Very good Condition
-Hood has some rock chips, BUT you're putting a CF hood on anyway right? SEE PIC.
-Passenger side has 2 SMALL, I MEAN SMALL dings. You really have to know where to look to even find them.
-Drivers side has 1 SMALL, I MEAN SMALL ding. Very hard to see on a white car.
-Small rust spot on bottom of rear quarter. SEE PIC.
Engine/Drivetrain:
-B16 cable tranny, NO GRINDS. Excellent condition.
-Tranny comes with starter.
-Tranny has NEW throwout bearing 8,000 miles old.
-Will include Clutchmasters heavy duty pressure plate 8,000 miles old.
-Will include Clutchmasters 6-Puck Cerametallic Disk. (Needs to be replaced)
-90-93 Integra axles. About 15k miles on axles. They were bought brand new.
-Will include 90-93 integra intermediate shaft.
-Cold Air Intake. (Needs new filter).
-Custom adjustable shift linkage.
-HCP Engineering EF18-X Motor Mounts. Passenger mount has tear in Poly. SEE PIC.
-New Radiator 15k Miles ago.
-Radiator hoses for b series swap.
-Stock exhaust with Cat to pass inspection.
-Custom Header Back 2 1/4" Exhaust. No Cat. With ractive muffler w/DTM tip.
-Stock crossmember.
-Modified crossmember for use with turbo, big header.
-B&M Fuel Pressure Gauge
-90-93 Integra Rear Mount
Electronics:
-Car is converted to OBD1, with JK OBD0-OBD1 conversion harness.
-Hondata Stage 2 N/A with ROMEditor Software, Chipped p28, Chip Burner all setup to tune your own car!
-Car is setup for use with peak & hold injectors. I have a set of stock 240's 15k miles old.
-Aiwa Mp3/CD Player.
-Sony XPlode 5 1/4" Speakers in doors.
Suspension/Wheels:
-Front rotors are 15k Miles old.
-Comes rolling on CRX Si Rims.
-I have two brand new tires to go with the car as well.
-Ground Control Coilovers BRAND NEW. Not installed.
-KYB GR-2 shocks BRAND NEW. Not Installed.
What you will need:
-B-Series DOHC VTEC Longblock with flywheel. (B16aX, B17a1, B18cX, ls/vtec, crv/vtec)
OR
-non-VTEC B-Series Longblock, you'll have to run an OBD1 LS ECU. And you can sell the Hondata setup for about $500. (B18aX, B18bX, B20bX, B20zX)
-90-91 Integra Clutch Disk. Doesnt matter which.
And thats it! You're ready to roll the fuck out!
Asking Price is: $2300 OBO.
Do your homework and see that this is an excellent price.
"Money talks, bullshit walks."
The car will be considered "FOR SALE" unless a deposit is made to my paypal account.
NO EXCEPTIONS.
If you have further questions, PM me for my Cell #.
AIM: FORCEinductedED6
Thank you and have a nice day.
