1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

GSR Distributer

Discussion in 'ECU's, Electronics, and Tuning' started by floridachill71, Nov 5, 2006.

  1. floridachill71

    floridachill71 Lean and Mean

    Messages:
    55
    Likes Received:
    0
    Joined:
    Oct 31, 2006
    Location:
    J-ville
    Hey guys, I'm trying to wire up my fuel injection controller for my FMax Turbonetics kit. It says im supposed to take off the distributer cap and wire the correct wires to the + and - terminals. Problem is, once i get the cover off, theres the wheel, and another plastic cover. I cant get past that to get to the terminals. Does anybody know how?
     
  2. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    its probably the connection on the ignitor (rectangle piece on the right)

    it just unscrews...
     
  3. floridachill71

    floridachill71 Lean and Mean

    Messages:
    55
    Likes Received:
    0
    Joined:
    Oct 31, 2006
    Location:
    J-ville
    heres a pic of it with the cover off. i dont see it?
     

    Attached Files:

  4. floridachill71

    floridachill71 Lean and Mean

    Messages:
    55
    Likes Received:
    0
    Joined:
    Oct 31, 2006
    Location:
    J-ville
    nevermind. there was a set screw on the shaft of the wheel. u have to turn the engine over by hand to get to it.
     
Verification:
Draft saved Draft deleted

Share This Page