1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

H22 Mount Cutting

Discussion in 'HYBRID -> BA-BB /CA-CD' started by Accordturbo94, Jun 14, 2003.

  1. Accordturbo94

    Accordturbo94 Senior Member

    Messages:
    920
    Likes Received:
    0
    Joined:
    Nov 18, 2002
    I was just wondering what everyone did to mount the timing side mounts when swapping the h22 in the accord! what side should i cut the one with the stud and run a new bolt and nut or cut the other side and just use the stud and throw a nut on there?
     
  2. dohcvtec_accord

    dohcvtec_accord WRX Sellout

    Messages:
    8,433
    Likes Received:
    1
    Joined:
    Sep 29, 2002
    Location:
    The left lane
    I used the Prelude engine-side mount and mated it to the Accord chassis-side mount. I'm only running one of the two bolts on there. You can drill a hole through it and use two bolts if you want, though.

    I was told that if you want to use the full Accord mount, you need to shave down the chasis-side a little to make it fit.
     
  3. Accordturbo94

    Accordturbo94 Senior Member

    Messages:
    920
    Likes Received:
    0
    Joined:
    Nov 18, 2002
    I just put a bolt through the preludes mount... and I am only running one bolt! It seems i didnt have to cut anything! Im happy
     
Verification:
Draft saved Draft deleted

Share This Page