1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

H22 Wiring Problems.....help!

Discussion in 'HYBRID -> BA-BB /CA-CD' started by WNYAccordLX, Apr 9, 2003.

  1. WNYAccordLX

    WNYAccordLX Junior Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Jan 23, 2003
    Well Im throwing a tps and a vtec solonoid code. I cent figure out why Im throwing vtec code, I ran a wire straight from solonoid tho ecu and still throws the code. I replaced the tps twice and still no luck, it runs the same no matter which ways I switch the 3 wires. I cant figure it out. Could the Tps being messed up have any thing to do with the vtec code?
     
  2. dohcvtec_accord

    dohcvtec_accord WRX Sellout

    Messages:
    8,433
    Likes Received:
    1
    Joined:
    Sep 29, 2002
    Location:
    The left lane
    I suppose the solenoid could be bad, or it could be dirty.

    Have you actually checked the voltage on your TPS?
     
  3. WNYAccordLX

    WNYAccordLX Junior Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Jan 23, 2003
    I have checked the voltage, at closed throttle it reads .5 at the tps. The tps input on the ecu reads 12.xx. How would I go about cleaning the solonoid?
     
  4. dohcvtec_accord

    dohcvtec_accord WRX Sellout

    Messages:
    8,433
    Likes Received:
    1
    Joined:
    Sep 29, 2002
    Location:
    The left lane
    Unbolt it, examine it for dirt/buildup. If it's dirty, spray the hell out of it with carb cleaner, let it dry and reinstall it. Was it noticeably damaged when you got your swap?
     
  5. WNYAccordLX

    WNYAccordLX Junior Member

    Messages:
    8
    Likes Received:
    0
    Joined:
    Jan 23, 2003
    no looks fine to me
     
  6. check out your ground for vtec. and for TPS, check for throttle blade looseness, usually this happens when your blade is loose.
     
Verification:
Draft saved Draft deleted

Share This Page