1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

H22a Skunk2 Intake Manifold

Discussion in 'Engine Building' started by dohcvtec_accord, May 28, 2003.

  1. dohcvtec_accord

    dohcvtec_accord WRX Sellout

    Messages:
    8,433
    Likes Received:
    1
    Joined:
    Sep 29, 2002
    Location:
    The left lane
    From an email I wrote to Skunk2:

    the SOHC manifold stepped in front of it unfortunately, last i found out it should be availiable in about 2 months...

    ----- Original Message -----
    From: Christopher Mirto
    To: info@skunk2.com
    Sent: Tuesday, May 27, 2003 12:50 PM
    Subject: Info on parts

    Hi, you've probably had this question asked of you more times than you can count, but I've been anxiously awaiting the intake mani for the H22A, and I was wondering if you have any info other than the "TBA" that's been on your site for as long as I can remember. Thanks for your time.
     
  2. Accordturbo94

    Accordturbo94 Senior Member

    Messages:
    920
    Likes Received:
    0
    Joined:
    Nov 18, 2002
    :doh:
     
  3. Havok

    Havok Senior Member

    Messages:
    6,827
    Likes Received:
    1
    Joined:
    Sep 28, 2002
    Location:
    Florida
    2 months is what all the shops kept telling me about the z6 IM...and the cam. Skunk2 Must be working with Endyn, using the same powerplant that is producing the supercharger.
     
  4. dohcvtec_accord

    dohcvtec_accord WRX Sellout

    Messages:
    8,433
    Likes Received:
    1
    Joined:
    Sep 29, 2002
    Location:
    The left lane
  5. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
Verification:
Draft saved Draft deleted

Share This Page