1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

H23....building For Boost

Discussion in 'Engine Building' started by XZILER8, Jun 23, 2003.

  1. XZILER8

    XZILER8 Senior Member

    Messages:
    262
    Likes Received:
    0
    Joined:
    Dec 30, 2002
    Location:
    Ne
    I'm looking to resleeve my h23a1 for boost.

    I'm having a bit of an issue finding information on aftermarket sleeves. Stock bore is 87mm right? What sleeves and what bore should I upgrade to?

    This is for a sunday driver / pleasure vehicle only. I'm planning on running a precision sc-34 @ medium to high boost
     
  2. XZILER8

    XZILER8 Senior Member

    Messages:
    262
    Likes Received:
    0
    Joined:
    Dec 30, 2002
    Location:
    Ne
    ttt.....lil help please
     
  3. E_SolSi

    E_SolSi Member of the 20 nut club Moderator VIP

    Messages:
    30,036
    Likes Received:
    3,970
    Joined:
    Sep 28, 2002
    Location:
    CT
    golden eagle are supposed to be good as are darton (sp?)
    dunno much about H series so someone else will be able to help a little more than me
     
  4. XZILER8

    XZILER8 Senior Member

    Messages:
    262
    Likes Received:
    0
    Joined:
    Dec 30, 2002
    Location:
    Ne
    well, I'm still looking for information. According to the reference section, my stock cylinder bore is 87mm. I found some very limited info on Dartons website saying there is a 87mm sleeve(which is no increase) with a max bore of 89mm.

    Is a 2mm increase worth the money and trouble?

    thanks

    Does it take a lot of specialized equipment to install new sleeves? I think they need to be "trued" up to make sure everything is aligned properly. Is this best left to the professionals? or can I do it?
     
Verification:
Draft saved Draft deleted

Share This Page