1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

h23 help

Discussion in 'Engine Building' started by BigT91, Aug 29, 2008.

  1. BigT91

    BigT91 New Member

    Messages:
    20
    Likes Received:
    0
    Joined:
    Aug 29, 2008
    Location:
    port charlotte, fl
    i have an h23a1 out of a 95 prelude and i need to know if my motor is blown. the pistons a scorched but not scorn or scratched. and the cylinder walls are burned badly as well. if i just clean and hone the walls and pistons will it be ok or will i need new pistons and shit.

    POST SHIT BACK I NEED TO KNOW ASAP TO GET SOME CASH TO PUT STUFF IN THE MOTOR.!!!1
     
  2. t3t4delsol

    t3t4delsol New Member

    Messages:
    652
    Likes Received:
    12
    Joined:
    Mar 18, 2008
    Location:
    York, Pa
    use a telescopeing guage and check the cylinder walls
     
  3. nootrac22

    nootrac22 Well-Known Member VIP

    Messages:
    4,331
    Likes Received:
    131
    Joined:
    Mar 16, 2007
    Location:
    exeter pa
    nothing that can't be fixed. if it's still good it can be honed or if it's bad you can have it resleaved.
     
  4. BigT91

    BigT91 New Member

    Messages:
    20
    Likes Received:
    0
    Joined:
    Aug 29, 2008
    Location:
    port charlotte, fl
    ok well i dont have a teloscoping gauge so what do i use if i dont.
     
Verification:
Draft saved Draft deleted

Share This Page