1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Header Clearance

Discussion in 'General Tech and Maintenance' started by Danabis, Apr 17, 2003.

  1. Danabis

    Danabis Member

    Messages:
    50
    Likes Received:
    0
    Joined:
    Dec 23, 2002
    I just swaped a b16a1 into my 91 crx si and noticed that my stock manifold barely clears the subframe and it didnt bolt right up to my stock cat so i wanted to run dc 4-1 but not sure if it would clear or even have decent ground clearance so maybe get thier 4-2-1 and for which car would i order it for since it has 2 o2 sensors? 88-91 integra? 94-97 del sol dohc vtec? or 96-2000 si? i plan on taking it somewhere and have them put a new cat on too maybe have them add a bung for it?
     
  2. GSRCRXsi

    GSRCRXsi Super Moderator Moderator VIP

    Messages:
    9,622
    Likes Received:
    345
    Joined:
    Nov 13, 2002
    Location:
    MD
    yea its the same way with my b18c in my 91 crx. im just going to get an aftermarket crossmember, you could always cut it, but i dont think that would be wise as it will probably weaken it
     
Verification:
Draft saved Draft deleted

Share This Page