1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help needed

Discussion in 'Engine Building' started by kushwave, Feb 16, 2010.

  1. kushwave

    kushwave New Member

    Likes Received:
    Feb 16, 2010
    So my d16 engine on my acura 1.6 el went to waste and i need to swap my motor to make my car run again. I am gettin a motor for $450 and it has the bottom end of a d16z6 and the head n manifolds of a d16y8. I was told that it would be a fit and all i would have to do is change the tensioner off of my old motor onto it. I just need some advice to know that i am not making a dumb decision. Thanks to everybody that replies to this.

Draft saved Draft deleted

Share This Page