1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help...??

Discussion in 'Engine Building' started by jangevines92teg, Apr 12, 2005.

  1. jangevines92teg

    jangevines92teg Member

    Messages:
    31
    Likes Received:
    0
    Joined:
    Mar 9, 2005
    I am lookin to build my block to high compression and i found some pistons i would like to buy. I Found P73 Pistons and these "Nippon Racing" Pistons off of Ebay witch are "domed to match " B16b Pistons. anyone have any sugestions??? :hmm:
     
  2. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    be careful. CTR pistsons not only have a huge dome, they also sit ABOVE the block/headgasket. most of the online calculators are WRONG with regards to ctr compression, because they don't take into fact the area above the deck that they sit. add about a full point of compression to the c-speed calculator.
     
  3. get_nick

    get_nick These snozzberries taste like snozzberries... VIP

    Messages:
    11,939
    Likes Received:
    1,059
    Joined:
    Apr 21, 2003
    Location:
    Washington State
    i was thinking about putting ctr pistons in my gsr swap. i was going to go with an almost all skunk2 head and stay all motor. what kind of compression should we expect to get out of b16b pistons?
     
  4. Slammed90Lude

    Slammed90Lude Senior Member

    Messages:
    3,733
    Likes Received:
    0
    Joined:
    Jan 13, 2003
    Location:
    milford, PA
    ctr's in a stock gsr blcok/head with no milling and a stock HG yeild 13.0-13.1:1 compression


    -pissedoffsol

    (he broke his internet)
     
Verification:
Draft saved Draft deleted

Share This Page