1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

hubs when doin a b18 swap into a crx

Discussion in 'HYBRID -> ED-EF / DA' started by B18CRX1988, Jul 29, 2003.

  1. B18CRX1988

    B18CRX1988 Junior Member

    Messages:
    14
    Likes Received:
    0
    Joined:
    Jun 28, 2003
    okay, i dont know if anyone has had luck with this why, but i have a 1988 crx hf and i used the knuckle of the CRX and used the hub from the integra, Well about 1 week after doing it, my wheel bearing went out, so i dunno if i did somthing wrong or if this kinda of thing cannot be done... Has anyone done this?? if so, have u had luck?? :blink:

    Thanks
     
  2. SleEPeR_CRX

    SleEPeR_CRX Senior Member

    Messages:
    1,226
    Likes Received:
    0
    Joined:
    Dec 22, 2002
    Location:
    Vancouver B.C. canada
    use Si/DX hubs, integra should work fine tho, i think u just got some bad luck.
     
  3. LS/VTecEF9

    LS/VTecEF9 Member

    Messages:
    49
    Likes Received:
    0
    Joined:
    Jun 26, 2003
    Yup dido. Try again.. if you used old or used hubs you don't know what conditon the bearing was in. Also when doing your swap did you ever push the car around with the motor out of the car and didn't leave your axles in the hubs cause if you do that it'll mess up the wheel bearings thaty could be the cause if you did do that.
     
  4. B18CRX1988

    B18CRX1988 Junior Member

    Messages:
    14
    Likes Received:
    0
    Joined:
    Jun 28, 2003
    well, it was the wheel bearing, got it fixed and it is good to go, i guess when i got the knuckle, the bearing was no good.. thanks guys
     
Verification:
Draft saved Draft deleted

Share This Page