1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

I need help!!

Discussion in 'Prelude' started by Jmaxima2001, Aug 13, 2008.

  1. Jmaxima2001

    Jmaxima2001 New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Aug 13, 2008
    I recently got a skunk2 intake manifold and a 72mm blox throttle body put on my 97 honda prelude. I was told in order for it to work properly i would have to get an obd1 ecu with a hondata chip and an obd1 distributor. So after I got all that installed my car does not run properly. It bogs down when I want to give it gas and sometimes the bog last for a few seconds before it will go again. At times it feels like the engine is jumping. I was told it could be my throttle positioning sensor but when I got all the stuff put on I also had a brand new TPS put on. Please, anyone give me some ideas of what I'm missing!?
    Thanks
     
  2. George777

    George777 ^^ Likes Bewbies

    Messages:
    2,917
    Likes Received:
    61
    Joined:
    Aug 17, 2005
    Location:
    With your mom
    Did you tune the ECU?
     
  3. BrutalB83

    BrutalB83 Brutal Moderator Moderator VIP

    Messages:
    11,620
    Likes Received:
    302
    Joined:
    Jun 24, 2006
    Location:
    Rochester Hills, MI
    Who told you that you needed to swap down to OBD1?
     
  4. moemoe

    moemoe PRELUDE JDM

    Messages:
    25
    Likes Received:
    0
    Joined:
    May 1, 2008
    Location:
    san antonio tx
    Did you calibrate the TPS sensor
     
Verification:
Draft saved Draft deleted

Share This Page