1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

IAC wiring for B18c NEED HELP

Discussion in 'HYBRID -> EG-EK / DC' started by gsrjennie, Sep 25, 2004.

  1. gsrjennie

    gsrjennie Junior Member

    Messages:
    15
    Likes Received:
    0
    Joined:
    Aug 30, 2004
    ok, first of all, my ride is a 97 HB dx swap with B18c obd1. the swap turn out well, but the only thing i'm stuck on is code 14 from the check light. i know that my stock dx motor have a 2 pin and a 3 pin connector, and the b18c obd1 only have the 2 pin connector. what i'm i suppost to do here with the 3 pin connector? i use my dx harness. please, any info will be helpful. thanks.
     
  2. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    [​IMG]
    [​IMG]
     
  3. gsrjennie

    gsrjennie Junior Member

    Messages:
    15
    Likes Received:
    0
    Joined:
    Aug 30, 2004
    THANKS for the info. i'll give it a try tomorrow. let me ask you one last question; ok, this is how i wire up the IAB: pink/blue wire to A26, the black to a ground. is this correct? it seems to run fine. and i'm running a obd1 P28 ecu. please correct me if this is the wrong way to wire it. thanks.
     
  4. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    From what I know, sounds right. I'm not to schooled in the 96+ swaps, but that is what I have seen as far as info goes, and what I would do if I was wiring in a GSR.
     
Verification:
Draft saved Draft deleted

Share This Page