1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

injector resistor box ??

Discussion in 'HYBRID -> ED-EF / DA' started by dragntoys, Feb 13, 2005.

  1. dragntoys

    dragntoys Member

    Messages:
    52
    Likes Received:
    0
    Joined:
    Mar 16, 2004
    im putting a 95 gsr motor in a 90 crx si i have been working on the engine harness for like half the day now swapping obd-0 connectors to obd-1 now im at the injector resistor box i have the 8 wire cap off off of the obd-1 harness
    my ? does the red/black wire connect to all the yellow and black wires?
    planning on soldering on the 8 wire cap someone said just solder them all together"??ive almost got this thing ready to go this is holding me up
    thanks chris
     
  2. Bl6CRX

    Bl6CRX Senior Member

    Messages:
    1,553
    Likes Received:
    0
    Joined:
    Jul 14, 2003
    Location:
    UCLA
    Im trying hard to remember what I did here when converting to obd1, the directions I got with the jumper harness say to solder them all together, but for some reason I think I did something else which i cannot remember now.
     
  3. droppedcrxsi

    droppedcrxsi Member

    Messages:
    52
    Likes Received:
    0
    Joined:
    Feb 18, 2005


    http://www.rywire.com/repininj.shtml
    You can re pin into a cap, or solder all together.
    Ryan
     
Verification:
Draft saved Draft deleted

Share This Page