1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

inlinePRO Headgaskets

Discussion in 'Forced Induction' started by AllMotorB18Civic, Mar 23, 2005.

  1. AllMotorB18Civic

    AllMotorB18Civic Junior Member

    Messages:
    15
    Likes Received:
    0
    Joined:
    Mar 1, 2004
    Has anyone used a inlinePRO Headgasket for a stock GSR and was able to run more than 15 pounds with good tuning??
    InlinePROs ad says they can safely hold up to 22 lbs of boost on stock motor with proper fuel management??
    If it can which thickness would I need there 2mm or 3mm????
     
  2. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    psi means nothing.

    20 psi out of a t1 is like 10 horsepower
    20 psi out of a t88 is like 600 horsepower.




    psi doesn't break motors- power does.

    stock sleeves are good for about 300 whp on a gsr.

    use oem gasket.

    and use uberdata/hondata/chrome/etc to tune with.
     
Verification:
Draft saved Draft deleted

Share This Page