1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Intermediate shaft seal

Discussion in 'HYBRID -> ED-EF / DA' started by crxmansir, Feb 3, 2004.

  1. crxmansir

    crxmansir Junior Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    Jun 24, 2003
    Location:
    In the mountains of GA
    I just put a obd 0 b16a with a y1 tranny in my 90 dx civic. The Last time I did this swap I used GSR Axles and Intermediate shaft. This time I have what I was told the jdm Intermediate off the Sir. Every thing is hunky dorry except where the intermediate goes into the tranny, the rubber seal is too small. I thought they were all the same size. The shaft is the right length and everything but is too thick so the seal for the civic/integra is too small. I thought the axle seal for civics/intergras were all the same. Any other application i could try? :spin: Please help. Thanks for all the help in the past.
     
Verification:
Draft saved Draft deleted

Share This Page