1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Its All About The Wiring

Discussion in 'HYBRID -> EG-EK / DC' started by honda_power69, Oct 13, 2002.

  1. honda_power69

    honda_power69 Member

    Messages:
    77
    Likes Received:
    0
    Joined:
    Oct 7, 2002
    I am swapping an SIR2 motor into my 1996 Civic DX. I currently have the entire ECU, and main engine wiring harnesses mapped out and finished. When I done with it all, I will be more than happy to share all of my information with everyone on how to convert to OBD1 using the 96-98 chassis. I also have about 8/10ths of the "ignition harness" finished. This is the harness that runs through the firewall on the driver-side rear (US Models) of the engine bay. There are about 5 or 6 wires in the harness connector (14 pin) that I am unsure of where to route. On my chassis, this is the same point where the single 10-pin connector for this harness is located. I have all of its wires mapped, I am just unsure of where to run some of the wires for the new harness. If anyone has any information on these connectors, it would be a great help, since this is all that I lack on finishing the swap. Thanks.
     
Verification:
Draft saved Draft deleted

Share This Page