Car: 95 cx hatch
Motor: JDM B16a SIR II (stock I/H/E)
ECU: chipped p28So I got the motor in this weekend, didnt hook up vtec, threw 4 codes.
20 - electrical load
21 - vtec solenoid
22 - vtec pressure
36 - traction control
I hooked it up last night, only got code 20, went for a test drive and I didnt feel it kick in.
I pulled over and checked the cells, got codes 20, 22, 36.
Today, i took out the vtec pressure pin, put it back in and again, only code 20.
I went for a test and didnt feel it once again, checked the cells and this time, codes 20, 21, 36.
Grounds have been checked, my oil level, both look good.
(Ive read that vtec wont engage if there are other codes. Is this true??)
i think if code 20 is eliminated, it will work.
Im kinda out of ideas though now. Can someone steer me in the right direction??
Motor: JDM B16a SIR II (stock I/H/E)
ECU: chipped p28So I got the motor in this weekend, didnt hook up vtec, threw 4 codes.
20 - electrical load
21 - vtec solenoid
22 - vtec pressure
36 - traction control
I hooked it up last night, only got code 20, went for a test drive and I didnt feel it kick in.
I pulled over and checked the cells, got codes 20, 22, 36.
Today, i took out the vtec pressure pin, put it back in and again, only code 20.
I went for a test and didnt feel it once again, checked the cells and this time, codes 20, 21, 36.
Grounds have been checked, my oil level, both look good.
(Ive read that vtec wont engage if there are other codes. Is this true??)
i think if code 20 is eliminated, it will work.
Im kinda out of ideas though now. Can someone steer me in the right direction??