1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Jdm D15b Into 97 Dx

Discussion in 'ECU's, Electronics, and Tuning' started by SolDave, May 6, 2003.

  1. SolDave

    SolDave Junior Member

    Messages:
    25
    Likes Received:
    0
    Joined:
    May 6, 2003
    Just wondering, since the D15B has VTEC, would a 96+ EX ECU work to control everything(except the VTEC)? What other options do I have the run this engine? Maybe an OBDI to OBDII pigtail?? I'm also guessing a 96+ SOHC VTEC wiring harness would be helpful
     
  2. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    The EX ECU is a vtec ECU,so it will control it.
     
  3. SolDave

    SolDave Junior Member

    Messages:
    25
    Likes Received:
    0
    Joined:
    May 6, 2003
    I would need to run seperate wires from the ECY to the VTEC solenoid though, right?? I'm guessing that the wire harness that goes from the ECU out doesn't have the VTEC wires pre-run.
     
  4. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    Yes,you'd have to run all the extras (vtec,knock).
     
  5. SolDave

    SolDave Junior Member

    Messages:
    25
    Likes Received:
    0
    Joined:
    May 6, 2003
    There's no knock sensor on the new motor. What would I do with the open lead?
     
Verification:
Draft saved Draft deleted

Share This Page