1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

JDM Type R Header 2.5" Collector

Discussion in 'Engine Building' started by khai_tuan_nguyen, Jun 14, 2004.

  1. khai_tuan_nguyen

    khai_tuan_nguyen Senior Member

    Messages:
    581
    Likes Received:
    0
    Joined:
    Jul 7, 2003
    Hi,
    I have hopefully an easy questions. Will a JDM Type R Header with the 2.5" collector fit on a b20b w/b16 vtec. I had issues when I bought my DCs. The gsr wouldn't fit nor did the B16s, they were too short to clear the oil pan, but an LS one did. So will the type r fit?

    also while anyone is at it, does anyone have one for sell?

    Thanks
    Khai
     
  2. MaaseyRacer

    MaaseyRacer Senior Member

    Messages:
    2,980
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    San Francisco, Ca.
    Yes the b20 and the b18 have the same deck height so it all should clear.
     
  3. khai_tuan_nguyen

    khai_tuan_nguyen Senior Member

    Messages:
    581
    Likes Received:
    0
    Joined:
    Jul 7, 2003
    B18A, but the B18C1 is different. Right? Because I could't use a header for a GSR, it didn't clear.

    Khai
     
  4. khai_tuan_nguyen

    khai_tuan_nguyen Senior Member

    Messages:
    581
    Likes Received:
    0
    Joined:
    Jul 7, 2003
    In the reference it shows the dec height of a gsr and an ls as equal, but I know that the GSR header didn't clear my oil pan.

    Anyone confirm?

    Thanks
    Khai
     
  5. pills_PMD

    pills_PMD Super Moderator

    Messages:
    4,232
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    New Albany, OH
    i used a b16 header on my ls/vtec in my del sol.. it was a header from a 95 del sol VTEC and (dc sports 4-1) and a b18a1 block..
     
Verification:
Draft saved Draft deleted

Share This Page