Loud clunk/bang noise from RF with Skunk2 Pro-S coilovers

[chwkef]

Hey guys

Just installed a set of skunk2 pro-s coilovers in my 90 EF last night. I'm running a B18A1, and knew about the crank pulley issues with rubbing on the traction bar, so I had it machined down. It's not hitting. I can get a couple of fingers between the top of my tire and the fenders no problem, but when going over medium-large bumps, I get a loud clunk from the left front. It sounds like when my coilovers in my old RX7 froze solid on my last winter.

Now I'm trying to figure out what it is. Could it be the trans hitting the traction bar? I guess I should mention I'm using hasport mounts. Anyone else experience this? Thanks in advance.

Dirk

 

[INJEN78]

it couldnt be the trans hitting you said its left front..is the car bottoming out underneath?
did you install the coiovers right?

 

[chwkef]

Yup, all installed properly. Double checked all bolts and they're all very tight. Especially the top hats. So it's not an issue with that.

Dirk

 

[91_stylin_civic]

is the upper arm hitting the inside of the fender. how are the ball joints?