1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ls vtec

Discussion in 'Engine Building' started by raifordmotors, Sep 13, 2004.

  1. raifordmotors

    raifordmotors Member

    Messages:
    38
    Likes Received:
    0
    Joined:
    Aug 27, 2004
    will i have to do any mods to ls rods when using itr pistons and if so what
     
  2. civicious

    civicious FüK-VTEC VIP

    Messages:
    9,855
    Likes Received:
    629
    Joined:
    Jun 15, 2003
    Location:
    Houston, TX
    Yes, you'll have to shave 1mm off each side. Just use PR3 (B16A) pistons. 10.4:1 compression, they bolt perfectly to LS rods, and they're teh cheaper than ITR's. USDM ITR's are lower compression than B16's anyways.
     
Verification:
Draft saved Draft deleted

Share This Page