1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Milling A F22a

Discussion in 'HYBRID -> BA-BB /CA-CD' started by RENR, Feb 13, 2003.

  1. RENR

    RENR Senior Member

    Messages:
    383
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    los angeles
    this is for the serious engine builders maybe you can help me out. whats the most you can safely mill a cylinder head on a f22a. ill be using a new stock head gasket. and want to run on 92octane without problems. thanks. its going to get done so please dont say im wasting my time and blah blah. thanks fellas. :blink:
     
  2. pills_PMD

    pills_PMD Super Moderator

    Messages:
    4,232
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    New Albany, OH
    i wouldn't mill it ANY more that .030" or else you will run into some piston hitting valve issues... but that's just me
     
  3. RENR

    RENR Senior Member

    Messages:
    383
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    los angeles
    cool, thanks i was gona cut .022 so i should be ok thanks bro. :rolleyes:
     
  4. ratherbewalking

    ratherbewalking Junior Member

    Messages:
    26
    Likes Received:
    0
    Joined:
    Dec 4, 2002
    whatever machine shop you take it to should be able to tell you what you can safley mill it.
     
Verification:
Draft saved Draft deleted

Share This Page