mini me swap ?

[00 civ&90 hatch]

i got a d15 block(no vtec) i was thinkin of pickin up a y8 or z6 head wat all would i need for the car to run with either of those i already have a p2p ecu(y8motor)anything else i need or any helpful tips would be appreciated thnx

 

[hondapartshero.com]

OBD1/OBD2 injectors, OBD2 Distributor, OBD0 to OBD2 ECU adaptor harness, OBD0-OBD2 distributor jumper or repin your factory plug to fit the OBD2's plug, if you use the P2P ECU you will need to find a way for the crank angle sensor to run on your crank because the Y8 has this on it. I would just do a Z6 head with a P28 ECU, OBD1 injectors and the Z6 distributor. You will need to eliminate the resistor box and remove the oil jet out of the head. And then run wiring for the VTEC and pressure switch