1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need help with willem dual power ASAP!

Discussion in 'ECU's, Electronics, and Tuning' started by 92CHB, Aug 6, 2005.

  1. 92CHB

    92CHB Senior Member

    Messages:
    707
    Likes Received:
    0
    Joined:
    Mar 23, 2004
    Location:
    Easthampton, MA
    I am having a few problems with my burner right now. When select the board type my board matches the picture for PCB3, but when i select willem it doesn't looks like it(from my understanding thats the board i am supposed to select in the program). So which board do i select on the program?

    Also i am keep getting a hardware error for power and connection. I have tried to get this to work on 2 different computers to no prevail. I followed projekteg's sticky on the UD forum through the whole process, except i have SST27SF512 chips.

    Any help would be more than appreciated!! Thanks!
     
  2. 92CHB

    92CHB Senior Member

    Messages:
    707
    Likes Received:
    0
    Joined:
    Mar 23, 2004
    Location:
    Easthampton, MA
    I did notice that if i didn't clamp the chip in it says the device is okay, but once i clamp down the chip it gives me the error.

    No one can help me??
     
  3. civic92jak

    civic92jak Senior Member

    Messages:
    255
    Likes Received:
    0
    Joined:
    Dec 13, 2003
Verification:
Draft saved Draft deleted

Share This Page