1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New Hondata problems

Discussion in 'ECU's, Electronics, and Tuning' started by SasSi, Feb 29, 2004.

  1. SasSi

    SasSi Senior Member

    Messages:
    333
    Likes Received:
    0
    Joined:
    Sep 30, 2003
    Location:
    Maryland
    I had everything working with my old setup. Now that I did the motor swap, I have the Hondata & ECU working properly, but now the shift light & clutch launch switch aren't working. Everything is connected, but we can't get the LED to work right. We've hacked into every wire on the ECU that had been hacked into before (when it was working right) & now it doesn't work!

    The light either stays on constantly or flashes constantly depending on which wires we have it connected to, but in either case the CEL won't come on with it. It's Sunday & Hondata is closed, otherwise I would've talked to them. I've tried to look at the "solutions" in the manual & there's no help there & can't find a troubleshooting guide.

    If anyone w/ Hondata experience can offer any help, I would greatly appreciate it!
     
  2. pills_PMD

    pills_PMD Super Moderator

    Messages:
    4,232
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    New Albany, OH
    where did you tap into the CEL for the shift ligth?
     
Verification:
Draft saved Draft deleted

Share This Page