1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

obd1 code and sensor issue b18b

Discussion in 'HYBRID -> EG-EK / DC' started by bigturbo, May 30, 2008.

  1. bigturbo

    bigturbo New Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    May 15, 2008
    Ok I just finished putting a b18b out of a 97 integra into my 95 del sol. I used the obd2 engine harness but used an obd1 ecu. When I was putting everything in I noticed there was nothing going to or from the sensoron the bottom of the throttle body. I believe its the intake air sensor. Does anyone know where the sensor feeds from and to? Also I threw a CEL and noticed when I jumped it I get one long flash or 10 which is low and behold the intake air temp sensor. A picture would be great if someone has one...Thanks
     
  2. LsTec

    LsTec civic525whp

    Messages:
    37
    Likes Received:
    1
    Joined:
    May 30, 2008
    Location:
    out side philly
    u could try googleing a pdf file of the wireing diagram for a 97 integra...
     
  3. bigturbo

    bigturbo New Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    May 15, 2008
    yes but its not the wiring, its the coolant routing lines
     
Verification:
Draft saved Draft deleted

Share This Page