1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

obx itbs vs skunk2 tb and im

Discussion in 'Engine Building' started by h22a hatch, Dec 5, 2011.

  1. h22a hatch

    h22a hatch New Member

    Messages:
    27
    Likes Received:
    0
    Joined:
    Oct 27, 2011
    hey...i have a swapped eg with a h22a motor in it..have basic bolt ons i/h/e and a tune...was wondering wat the pros n cons were of the obx itb's..i orginally was going to get the skunk2 throttle body and intake manifold of ebay but the obx itb's are actually cheaper and my one buddy who is building a lude said i would like the better throttle response of the itb's more and would get more of a power gain from them..was wondering on ppls opinion on which setup would make more power...i plan on staying na
     
  2. serrilion

    serrilion In my own little world! VIP

    Messages:
    1,758
    Likes Received:
    42
    Joined:
    Aug 13, 2007
    Location:
    Vermont
    OBX is a cheap IM and works well for the most part, skunk is a proven race manifold, cost more, but imo is a bit better for now and future aplications
     
  3. Topher

    Topher New Member

    Messages:
    2
    Likes Received:
    1
    Joined:
    Aug 29, 2011
    hes not talkin about the obx intake manifold, hes talking about the ITBs
     
Verification:
Draft saved Draft deleted

Share This Page