1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Opinions on Buddyclub Cams??

Discussion in 'Engine Building' started by thompy.mark, Mar 24, 2008.

  1. thompy.mark

    thompy.mark New Member

    Messages:
    14
    Likes Received:
    0
    Joined:
    Sep 5, 2007
    I have a set of BC spec 3+ cams waiting to go into an engine, but have recently heard that they are quite hard on rockers.

    Has anyone out there had much experience with these cams? thoughts??

    thanks
     
  2. LS_VTEC

    LS_VTEC you get the BRAKE

    Messages:
    2,616
    Likes Received:
    25
    Joined:
    Dec 11, 2007
    Location:
    NJ
    I hope whatever head they are going into is built with dual valve springs and strong retainers. Those cams are for high rpm, so be prepared to make crap power down low-mid but make some nice power upwards of 9,000 rpm.
     
  3. dtob

    dtob New Member

    Messages:
    578
    Likes Received:
    2
    Joined:
    Mar 18, 2007
    Go buy a set of type r cams if you are worried about cam followers.
     
Verification:
Draft saved Draft deleted

Share This Page