1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

P28 Auto ECU doesn't have a RP18 resistor???

Discussion in 'ECU's, Electronics, and Tuning' started by WinningJDM, Jun 19, 2011.

  1. WinningJDM

    WinningJDM New Member

    Messages:
    19
    Likes Received:
    0
    Joined:
    Jun 4, 2011
    I'm looking at a P28 L50 which is an Auto so why when I open it up I don't see the RP18 Resistor? RP17 is there but no RP18. Will this unit have different instructions when converting to Manual?

    It looks untouched for sure definitely factory.
     
  2. RHDism

    RHDism Right Hand Drive guru

    Messages:
    259
    Likes Received:
    9
    Joined:
    May 1, 2011
    If thats the case..you have a one of a kind ECU...post some pix..
     
  3. WinningJDM

    WinningJDM New Member

    Messages:
    19
    Likes Received:
    0
    Joined:
    Jun 4, 2011
    Well I went ahead and removed rp17 resistor and it looked totally different than rp18 so for sure it looks like rp18 resistor was never there from factory. I also didn't use a jumper on 18.

    It's in the car now code 19 is gone. :)
     
Verification:
Draft saved Draft deleted

Share This Page