1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

P28 Ecu For A Gsr Swap

Discussion in 'HYBRID -> EG-EK / DC' started by alloveryou, May 6, 2003.

  1. alloveryou

    alloveryou Junior Member

    Messages:
    15
    Likes Received:
    0
    Joined:
    May 4, 2003
    I'm dropping a 95 B18C1 in my 92 EG6, with a chipped P28 ecu with the Skunk2 program. I was told that you don't need to wire for the knock sensor if you run the P28 instead of the P72. Anybody know anything of this? Any help would be appreciated.Thanks.
     
  2. honda_mach3

    honda_mach3 Senior Member

    Messages:
    113
    Likes Received:
    0
    Joined:
    Apr 28, 2003
    nopes, no knock sensor on the S2 chip, the main thing here is, the S2 chip does not look for a knock to actuate VTEC, which means they actually disabled knock. The problem with the S2 chip is that it runs pretty rich, richer than the mugen. but thus, a great program. some tuning when the ECU install will be some cam timing, advance more on intake, and retard more on exhaust. if you have a dyno, keep adjusting it till reach best timing.
     
Verification:
Draft saved Draft deleted

Share This Page