1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

p28 ecu problems

Discussion in 'ECU's, Electronics, and Tuning' started by htchbck527, Jan 21, 2007.

  1. htchbck527

    htchbck527 New Member

    Messages:
    20
    Likes Received:
    0
    Joined:
    Jan 10, 2007
    I just put in a d16z6 with a p28 computer in my car. When its cold, everything is fine. When it gets warm, a yellow light comes on and stays on. My vtec doesnt work at all. How do i jump the ecu wire or how do i go about fixing this?
     
  2. jeffsciv23

    jeffsciv23 Senior Member

    Messages:
    374
    Likes Received:
    2
    Joined:
    Nov 21, 2002
    Location:
    Wa
    you mean the check engine light comes on? there is a "service pin connector" behind the kick panel on the passenger side next to the ecu. if you can't find it look in your haynes manual or chiltons. all you do is take a paper clip and jump the two wires. if you look in the referance section there is a post about CEL codes that tells you what the codes are. if you still can't figure it out goto Schucks or somethign liek that, i tihnk they read codes for free.


    http://hondaswap.com/reference-materials/88-ecu-error-codes-29109/
     
Verification:
Draft saved Draft deleted

Share This Page