1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

pin out for 93 jdm h22 in 96 accord lx???

Discussion in 'HYBRID -> BA-BB /CA-CD' started by azzinine1, Jan 11, 2005.

  1. azzinine1

    azzinine1 Junior Member

    Messages:
    5
    Likes Received:
    0
    Joined:
    Jan 11, 2005
    I have anOBDII to OBDI conversion harness from boomslang.com and listed below are the pin location information that I have. the info I have says to pin the following to to the accord bulk head (the actual clips that connect to the ecu incase I have the name wrong) I just wanted to see if anyone knows if this is correct or not and also if anyone can give me a diagram of the pin order for a 96 lx accord on the "bulk head" once again if thats the right name...thanks for your time.

    VTEC solenoid to pin A8
    VTEC pressure switch to pin C15
    IAB pin A26
    Knock sensor pin D6
     
  2. rival12

    rival12 Junior Member

    Messages:
    7
    Likes Received:
    0
    Joined:
    Jan 10, 2005
    I'm in the same boat, i think i'm going to go to Honda and ask one of the mechanics for it, they should have it in one of the service manuals. Goodluck, let me know if you find anything.
     
  3. azzinine1

    azzinine1 Junior Member

    Messages:
    5
    Likes Received:
    0
    Joined:
    Jan 11, 2005
    Same to you if you find out let me know 6 months no car im goin nuts. thanks
     
  4. bee619

    bee619 Junior Member

    Messages:
    3
    Likes Received:
    0
    Joined:
    Dec 27, 2004
    How i was going to wire up my 96 ex.

    I got a obdII to obdI harness then added the IAB and knock sensor since my car already had vtec. I did my wiring off the harness to keep things simple.

    vtec pressure switch
    wire color : light blue on prelude
    ecu connection : connect to pin d6 on the ecu
    location of pressure switch : near distributor

    vtec soleniod
    wire color : green/yellow on prelude harness
    ecu connection : connect to pin a4 on the ecu
    location of solenoid : near distributor

    intake air bypass solenoid
    wire color : pink on prelude harness
    black/yellow -12v
    black/red > ground
    ecu connection : connect to pin a17 on the ecu
    location of solenoid : driver's side of the intake manifold

    knock sensor
    wire color : red/blue on prelude harness
    ecu connection : connect to pin d3 on the ecu
    location of sensor : intake side of the motor, towards the middle of the engine block

    You also have to extend some wires
    -intake air temp
    -map
    -egr lifter solenoid
    -02 sensors
    -iac valve

    switch pin a6 (egr solenoid) and a11 (h02s heater) at the ecu

    I'm pretty sure i got it right, haven't plugged in car yet since i have no tranny...
    Let me know how it goes..

    refer to this if you need
    http://www.sportcompactcarweb.com/tech/0311scc_hybrid/
     
Verification:
Draft saved Draft deleted

Share This Page